Update method 2: Manual update via the Internet
When the home audio system is connected to the Internet via a wired or Wi-Fi network, [UPDATE] lights up on the display when the home audio system detects a new software version.
In this case, follow the steps below to update the software to the latest version. Use the remote control to perform the steps below.
When the update starts, any music being played will stop. Also, any BLUETOOTH connection is disconnected.
-
Press OPTIONS button.
-
Press
/
button repeatedly to select [SYSTEM], then press 
(enter) button. -
Press/ button repeatedly to select [UPDATE], then press (enter) button.
-
Press/ button repeatedly to select [VIA NW], then press (enter) button.
-
Press/ button repeatedly to select [EXEC], then press (enter) button.
-
Press/ button repeatedly to select [YES], then press (enter) button.
When updating starts, the information of the update’s progress appears on the display. While updating, the home audio system cannot be operated.
To exit the options menu, press OPTIONS button.
[UPDATED] appears on the display and the home audio system enters standby mode or BLUETOOTH/Network standby mode automatically when the updating is completed.
When the home audio system is turned on for the first time after updating, [UPDATED] appears on the display.
If [NETWORK ERROR] or [DOWNLOAD ERROR PUSH POWER] appears on the display
The update has failed.
If the network connection is not reliable, the update may fail before it completes. See the following to update using a USB flash drive.
Manual update via a USB flash drive (when the update via a network has failed)
Hint
- During an update, the information of the update’s progress appears on the display, and [UPDATED] appears on the display when the update is complete. Do not turn the home audio system off during the update.
Note
- Updating normally takes 3 to 10 minutes. It may take longer depending on your network environment.
- Do not operate the home audio system during an update. Keep the home audio system connected to the power supply and network while updating.
- While updating via the Internet, you can terminate the update procedure by pressing the
(stop) button on the remote control or touching the (stop) key on the home audio system when [DL XX%] appears on the display (This is not always possible). If you cancel the update, [CANCEL] appears on the display and [UPDATE] will stay lit on the display again.
