Personal Audio SystemSRS-X7

Precautions

On safety

The nameplate indicating Sony trademark, model number and electrical rating is located on the bottom exterior of the speaker.

The MAC address is located on the bottom exterior of the speaker.

  • Before operating the speaker, be sure that the operating voltage of the speaker is identical with that of your local power supply.
    • Where purchased: all countries/regions
    • Operating voltage: varies depending on the country/region.

Notes on the AC adaptor

  • When connecting or disconnecting the AC adaptor, turn off the speaker beforehand. Otherwise, it may cause malfunction.
  • Use only the supplied AC adaptor. To avoid damaging the speaker, do not use any other AC adaptor.

    Polarity of the plug

  • Plug the AC adaptor into a nearby wall outlet (mains). In the case of a problem, unplug it from the wall outlet (mains) immediately.
  • Do not install the AC adaptor in a confined space, such as a bookcase or built-in cabinet.
  • To reduce the risk of fire or electric shock, do not expose the AC adaptor to dripping or splashing, and do not place objects filled with liquids, such as vases, on the AC adaptor.
  • The validity of the CE marking is restricted to only those countries where it is legally enforced, mainly in the countries EEA (European Economic Area).

On placement

  • Do not set the speaker in an inclined position.
  • Do not leave the speaker in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock.

On operation

  • Do not insert any small objects, etc., into the jacks or ventilation hole on the rear of the speaker. The speaker may short out or malfunction.

On cleaning

  • Do not use alcohol, benzine, or thinner to clean the cabinet.

Others

  • If you have any questions or problems concerning the speaker that are not covered in this Help Guide, please consult your nearest Sony dealer.
  • When disposing of or giving away the speaker, make sure to initialize it to reset all settings to the factory defaults.