DSC-HX100/HX100V | Battery pack and power | Cyber-shot User Guide

Top page > Troubleshooting > Troubleshooting > Battery pack and power

Battery pack and power

Cannot insert the battery pack into the camera.

Make sure the direction of the battery pack is correct, and insert it until the battery eject lever is locked.

Cannot turn on the camera.

After inserting the battery pack into the camera, it may take a few moments for the camera to power up.

Make sure that the battery pack is inserted correctly.

The battery pack is discharged. Charge the battery pack.

The battery pack terminals are dirty. Gently wipe away any dirt with a soft cloth.

Check that the battery pack is NP-FH50.

The power turns off suddenly.

Depending on the camera and battery temperature, the power may turn off automatically to protect the camera. In this case, a message is displayed on the LCD screen before the power turns off.

If you do not operate the camera for a certain period of time while the power is on and [Power Save] is set to [Standard] or [Stamina], the camera turns off automatically to prevent wearing down the battery pack. Turn on the camera again.

The remaining charge indicator is incorrect.

This is caused when you use the camera in an extremely hot or cold location.

A discrepancy arose between the remaining charge indicator and the actual remaining battery charge. Fully discharge the battery pack once, then charge it to correct the indication. The remaining charge indicator may not be correct under certain circumstances.

Battery capacity decreases over time and through repeated use. If decreased usage time between charges becomes significant, it is probably time to replace it with a new one.

The Power/charge lamp of the camera flashes while charging the battery.

Check that the battery pack is NP-FH50.

This is caused when you use the camera in an extremely hot or cold location.

Reload the battery pack, being sure to insert it correctly. If the lamp continues to flash, the camera may need to be repaired. Unplug the camera and contact a Sony service center.

The Power/charge lamp is not lit while the battery is charging.

Reload the battery pack, being sure to insert it correctly.

Plug the cord into the wall socket correctly.

The battery pack is already finished charging.

The battery is not charged even if the Power/charge lamp turns off and charging is finished.

This happens when you charge the battery pack in an extremely hot or cold location. Charge the battery pack within the proper charging temperature range of between 10°C to 30°C (50°F to 86°F).