DSC-TX200/TX200V | GPS setting (DSC-TX200V only)

Top page > Changing settings > Main Settings > GPS setting (DSC-TX200V only)

GPS setting (DSC-TX200V only)

Checking triangulating status and shooting direction

The built-in GPS and direction sensor of this camera acquire the information on location or the shooting direction, and record it on images.

Using the software “PlayMemories Home,” you can import photos and movies recorded with location and shooting direction information to a computer and enjoy viewing them with a map which shows their shooting location. See “PlayMemories Home Help Guide” for details.

MENU (Settings) (Main Settings) [GPS setting] desired mode

	On	GPS direction sensor is activated.
	Off	GPS direction sensor is inactivated. Set this to not record location and direction information.

To receive a GPS signal

Proper triangulation is not possible indoors or near tall buildings. Use your camera in an open area outside, and turn on your camera again.

If no triangulation icon appears, even if you wait for several minutes, you may be in an area where GPS signal reception is difficult or impossible. Begin shooting where you are, or move to an open area outside. If you shoot where you are, no location information will be recorded.

Notes

The shooting direction is not recorded when shooting movies.

During take off and landing of an airplane, set [Airplane Mode] to [On] (DSC-TX200V only).

Use GPS in accordance with the regulations of the place or situation.

It may take from several tens of seconds to several minutes to acquire the location information when you use the GPS for the first time or use it again after long intervals. Triangulating time can be shortened by taking in GPS assist data. [Details]

The information on the shooting direction acquired by this camera is based on magnetic north (the direction a compass needle points).

If the camera is in close proximity to a magnetic source or a metal, an error may arise in the direction sensor. Keep the camera away from a magnetic source or a metal, if at all possible.

The correct shooting direction may not be recorded or displayed in the following cases:

Near a building, a footbridge, an iron bridge, a vehicle, an iron tower

Near electric apparatus, such as a television, speaker, refrigerator, mobile phone, headphones

Near a steel desk or steel chair, etc.

Direction information will become unstable if this camera is pointed upwards.

In searching the satellite positions or triangulating, its may fall when you put your fingers on the GPS receiver.

Checking triangulating status and shooting direction

The indicator changes according to the strength of GPS signal reception when GPS is activated. The triangulating status can also be checked using [Position Information]. [Details]

You can check the shooting direction with the direction icon displayed on the screen.

Triangulating status	GPS indicators	GPS reception status
Off	No indicator	[GPS setting] is set to [Off] or an error occurred.
Difficult		Your camera cannot find a GPS signal, therefore, it cannot acquire the location information. Use your camera in an open area.
Searching		Searching for GPS satellites. It may take several minutes to start triangulating.
Triangulating		Your camera is receiving a GPS signal, and can acquire location information.