Charging the battery pack using your computer
-
Close the LCD screen.
-
Open the battery/memory card/jack cover.
-
To open the battery/memory card/jack cover, slide and hold the cover lock lever (), then slide the cover down slightly () and flip it open ().
-
Connect the camcorder to a running computer using the USB cable ().
Charging time
-
The charging times shown in the table above are measured when charging the camcorder at a temperature of 25 °C (77 °F). It is recommended that you charge the battery in a temperature range of 10 °C to 30 °C (50 °F to 86 °F).
To remove the battery pack
-
Close the LCD screen, then slide down and open the battery/memory card/jack cover while sliding and holding the cover lock lever.
-
Slide the battery release lever () and remove the battery pack ().
-
Make sure that the battery does not fall out.
On the power supply
-
Insert the battery into the camcorder before connecting it to a power supply either by connecting the camcorder to the AC Adaptor or the computer.
-
The recording mode can be selected only when the camcorder is connected to the AC Adaptor or a computer which is compatible with a 1,500 mA standard power supply.
-
When you connect the camcorder to a computer using the USB cable during playback, the USB connection screen appears. It will turn to the Playback screen if you touch (View Images).
To check the remaining battery power
|
|
|
|
|
High
|
|
Low
|
Empty
|
-
It will take approximately 1 minute to display the correct remaining battery power.
-
The remaining battery power may not be displayed correctly depending on ambient conditions and the environment in which you are using your camcorder.
-
Your camcorder cannot display the remaining battery life in minutes using the “InfoLITHIUM” battery.