Attaching the supplied accessories

To attach the lens hood

Align the lens hood with the camcorder properly (), then turn the securing ring of the lens hood in the direction of the arrow ().

• When attaching the lens hood, align the opening section of the lens hood with the flash-emitting section of the camcorder properly.

• To remove the lens hood, turn the securing ring of the lens hood in the opposite direction from that of the arrow.

• Remove the lens hood when you operate the camcorder with the supplied remote commander.

To attach the Step Down Ring

Align the Step Down Ring with the camcorder properly (), then turn it in the direction of the arrow until the Step Down Ring is locked in place ().

• You can change the filter diameter to 37 mm (1 1/2 in.) by attaching the Step Down Ring, allowing you to use the recommended conversion lens.

• You cannot attach the wide end conversion lens/wide conversion lens, if the Step Down Ring is attached.

• To remove Step Down Ring, turn it in the opposite direction from that of the arrow.