Pairing and connecting with a BLUETOOTH device

  1. Place the BLUETOOTH device within 1 meter of the system.

  1. Slide the POWER switch to turn on the system.

The system enters pairing mode automatically in the default setting.
The  (BLUETOOTH) indicator (blue) flashes fast in pairing mode.
To enter pairing mode the next time you use the system, slide and hold the switch to the PAIRING side for about 2 seconds when the system is turned off. The system beeps when it enters pairing mode.
  1. Perform the pairing procedure on the BLUETOOTH device to detect the system.

When the list of detected devices appears on the display of the BLUETOOTH device, select “SRS-BTV5.”
If passkey input is required on the display of a BLUETOOTH device, input “0000.”
A Passkey may be called a “Passcode,” a “PIN code,” a “PIN number,” or a “Password.”
  1. Make the BLUETOOTH connection from the BLUETOOTH device.

When the connection is made, the  (BLUETOOTH) indicator (blue) lights up.
  • To pair with other BLUETOOTH devices, repeat steps 1 to 4 for each device.

  • To delete all pairing information, see “What can I do to solve a problem?” [Details]

  • For details, refer to the operating instructions supplied with the BLUETOOTH device.

  • When pairing with a BLUETOOTH device that cannot display a list of detected devices or that has no display, you may pair the device by setting both the system and the BLUETOOTH device to pairing mode. At this time, if passkey is set besides “0000” on the BLUETOOTH device, pairing cannot be done with the system.

  • Once BLUETOOTH devices are paired, there is no need for pairing again, except in the following cases:

  • Pairing information is deleted after repair, etc.

  • The system is paired with 5 or more devices. The system can be paired with up to 4 devices; if a new device is paired after 4 devices have been paired, the device whose latest connection time is the oldest among the 4 paired devices is replaced by the new one.

  • When recognition of the system by the device to be connected is deleted.

  • The system is initialized. All pairing information is deleted.