Charging the battery pack using your computer

1. Close the LCD screen.

2. Open the battery/memory card/jack cover.

• Slide the cover lock lever () to slide back the battery/memory card/jack cover (). Then open the battery/memory card/jack cover ().

3. Connect the camcorder to a running computer using the USB cable ().

: To the wall outlet (wall socket)

Charging time

• The charging time shown above is measured when charging the camcorder at a temperature of 25 °C (77 °F). It is recommended that you charge the battery in a temperature range of 10 °C to 30 °C (50 °F to 86 °F).

To remove the battery pack

1. Close the LCD screen, slide the cover lock lever to slide back the battery/memory card/jack cover, and then open the battery/memory card/jack cover.

2. Slide the battery release lever () and remove the battery pack ().

• Make sure that the battery does not fall out.

On the power supply

• Insert the battery into the camcorder before connecting it to a power supply either by connecting the camcorder to the AC Adaptor or the computer.

• The recording mode can be selected only when the camcorder is connected to the AC Adaptor or a computer which is compatible with a 1,500 mA standard power supply.

• When you connect the camcorder to a computer using the USB cable during playback, the USB connection screen appears. It will turn to the Playback screen if you select [Yes].

To check the remaining battery power

High			Low	Empty

• It will take approximately 1 minute to display the correct remaining battery power.

• The remaining battery power may not be displayed correctly depending on ambient conditions and the environment in which you are using your camcorder.

• Your camcorder cannot display the remaining battery life in minutes using the “InfoLITHIUM” battery.