Method 1. Setting up a network connection using the WPS push button configuration method
If your wireless LAN router/access point has a WPS button, you can easily connect the HDD AUDIO PLAYER to a Wi-Fi (wireless LAN) network.
If your wireless LAN router has an AOSS button or other easy setup button, it may support WPS. Check the operation manual of your wireless LAN router/access point for details.
- Select [Settings] - [Network Settings] - [Internet Settings].
- Select [Wireless Setup].
- Select [Wi-Fi Protected Setup (WPS)].
- Select [Start] and then press the WPS button on your wireless LAN router/access point.
The HDD AUDIO PLAYER starts searching for the access point.
- When the connection is made, confirm the registration completion message that appears on the screen and then select [Next].
- When the network setup is completed, select [OK] on the screen.
Note
- If you cannot connect to a network correctly, the following reasons are possible. Try the connection again or use another connection method.
- You pressed the WPS button more than two minutes after selecting [Start] in step 4.
- The WPS button may have to be pressed and held for about two minutes (depending on the router).
- You cannot cancel the connection after the HDD AUDIO PLAYER has started connecting to the network.
- Do not turn the power off while the HDD AUDIO PLAYER is connecting to the network.
Hint
- For details on the name and position of the WPS button on your wireless LAN router/access point, refer to the operating manual of the router/access point.