MULTI CHANNEL AV RECEIVERSTR-DN1060/STR-DN860

Reverting to the factory default settings

You can clear all memorized settings and restore the receiver to the factory default settings by the following procedure. This procedure can also be used to initialize the receiver before you use it for the first time.
Be sure to use the buttons on the receiver to perform this operation.

  1. Turn off the receiver.
  2. Hold down (on/standby) on the receiver for 5 seconds.

    [CLEARING] flashes on the display panel for a while, then changes to [CLEARED !].

Note

  • It takes a few minutes for the memory to be cleared completely. Do not turn the receiver off until [CLEARED !] appears on the display panel.
Go to Page Top