5. Performing Auto Calibration
You can perform automatic calibration from where you are sitting.
- Select [Setup] - [Speaker Settings] from the home menu.
- Select [Auto Calibration].
- Follow the instructions on the TV
screen, then press
to select [Start].
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches. - Select the item you want.
- Save: Saves the measurement results and exits the setting process.
- Retry: Performs the Auto Calibration again.
- Discard: Exits the setting process without saving the measurement results.
- Save the measurement results.
Select [Save] in step 4.
Note
- If an error code or warning message appears on the screen in step 3, see “List of messages after Auto Calibration measurements.”
- This setting is not available when headphones are connected.
Hint
- The Auto Calibration function will be canceled if you perform the following during the measurement process:
- Press
. - Press the input buttons on the remote control or turn INPUT SELECTOR on the receiver.
- Press
. - Press SPEAKERS on the receiver.
- Change the volume level.
- Connect headphones.
- Press