MULTI CHANNEL AV RECEIVERSTR-DN1060/STR-DN860

Turning the power for Zone 2/Zone 3/HDMI zone on/off (Power) (for STR-DN1060 only)

You can turn the power for Zone 2/Zone 3/HDMI zone on or off by following the steps below.

  1. Select [Setup] - [Zone Settings] from the home menu.
  2. Select [Zone2 Power], [Zone3 Power] or [HDMI Zone Power].
  3. Select [On] or [Off].

Note

  • The amplifiers in the zones other than the main zone remain turned on even when the receiver is in standby mode (press (on/standby) on the remote control to turn off the receiver).
  • When the receiver is in standby mode, the on/standby indicator on the front panel lights up in amber if the power for Zone 2/Zone 3/HDMI zone is turned on.

Hint

  • You can also turn the power for Zone 2/Zone 3/HDMI zone on or off using ZONE POWER on the receiver.
Go to Page Top