Adjusting the balance between adjacent speakers by outputting a test tone (Phase Noise)
You can output a test tone from adjacent speakers to adjust the balance between the speakers.
This operation is only available using the display panel on the front of the receiver.
- Press AMP MENU.
The menu is displayed on the display panel of the receiver.
- Select [<LEVEL>] (Level settings) - [P. NOISE].
- Select the speakers to output the test tone from.
The test tone is output from the selected speakers.
- Adjust the speaker level using MASTER VOLUME on the receiver.
Available speakers:
FL/FR (Front Left/Front Right)
FL/CNT (Front Left/Center)
CNT/FR (Center/Front Right)
FR/SR (Front Right/Surround Right)
SR/SBR (Surround Right/Surround Back Right)
SR/SB (Surround Right/Surround Back)
SBR/SBL (Surround Back Right/Surround Back Left)
SR/SL (Surround Right/Surround Left)
SBL/SL (Surround Back Left/Surround Left)
SB/SL (Surround Back/Surround Left)
SL/FL (Surround Left/Front Left)
LH/RH (Left Front High/Right Front High)
FL/SR (Front Left/Surround Right)
SL/FR (Surround Left/Front Right)
FL/RH (Front Left/Right Front High)
LH/FR (Left Front High/Front Right)
Note
- Some items may not appear, depending on the connected speakers.
- This function is canceled if you perform any operation other than the following:
- Volume adjustment
- Level adjustment of each speaker
- Turning the muting function on/off
- This function is not available when [Bluetooth Mode] is set to [Transmitter].
Hint
- Select [OFF] in step 3 to disable the Phase Noise function.