USB DAC AMPLIFIERUDA-1

Standby mode

If you switch the AUTO STANDBY switch on the rear panel of the USB DAC AMPLIFIER to “ON, ” when you are not using the USB DAC AMPLIFIER or there is no digital signal input to the USB DAC AMPLIFIER for 20 minutes, the unit is automatically turned off and enters standby mode to reduce the power consumption.

Before the USB DAC AMPLIFIER switches to standby mode, the lamp flashes for 1 minute, and then the lamp turns off.

Note

  • If a very short audio signal of only a few seconds duration is input, the sound may not be detected as an audio input, and the USB DAC AMPLIFIER may switch to standby mode.
  • Even when no digital audio is input, the USB DAC AMPLIFIER may not switch to standby mode due to the operation of other devices connected, or due to connection/disconnection of the cables.

Hint

  • When the USB DAC AMPLIFIER is in standby mode, you can start the USB DAC AMPLIFIER only by pressing the button on the remote control or the unit.
Go to Page Top