Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 4 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 20 watts per channel minimum RMS power, with no more than 10% total harmonic distortion from 250 milliwatts to rated output.
Amplifier section
Reference Power Output
23 W + 23 W (4 ohms, 1 kHz, THD 10%)
Rated Power Output
20 W + 20 W (4 ohms, 20 Hz - 20 kHz, THD 10%)
Speaker impedance match
4 ohms - 16 ohms
S/N ratio
LINE IN: 100 dB (short-circuit input, 20 kHz LPF, A Network)
USB IN: 100 dB (20 kHz LPF, A Network)
Frequency response
10 Hz - 100 kHz (+0 dB, –3 dB) (4 ohms, LINE IN)
Input section (digital)
USB REAR (USB-B jack)
USB 2.0 compatible
Supported format: PCM (Sampling frequency: 44.1 k/48 k/88.2 k/96 k/176.4 k/192 kHz, data bit length: 16/24/32 bits), DSD (2.8 M/5.6 MHz)
USB FRONT (USB-A jack)
USB 2.0 compatible
Supported format: PCM (Sampling frequency: 32 k/44.1 k/48 kHz, data bit length: 16bits)
COAXIAL jack
Input impedance: 75 ohms
Supported format: PCM (Sampling frequency: 32 k/44.1 k/48 k/88.2 k/96 k/176.4 k/192 kHz, data bit length: 16/24 bits)
OPTICAL jack
Supported format: PCM (Sampling frequency: 32 k/44.1 k/48 k/88.2 k/96 kHz, data bit length: 16/24 bits)
Input section (analog)
Input sensitivity: 500 mV
Input impedance: 100 kilohms
Output section
LINE OUT
Output voltage: 2 V
Output impedance: 2.2 kilohms, 2 Hz - 80 kHz (–3 dB)
PHONES
17 mW + 17 mW (8 ohms, THD 1%)
55 mW + 55 mW (32 ohms, THD 1%)
170 mW + 170 mW (300 ohms, THD 1%)
General and others
Power requirements
Models for the USA and Canada: AC 120 V 60 Hz
Models for Europe: AC 220 - 240 V 50/60 Hz
Power consumption
On: 65 W
During standby mode: 0.3 W
Dimensions (approx.) (w/h/d)
225 mm × 74 mm × 262 mm (8 7/8 inch × 3 inch × 10 3/8 inch) including projecting parts and controls
Mass (approx.)
4.0 kg (8 lbs 14 oz)
Supplied accessories
See “Supplied accessories.”
Design and specifications are subject to change without notice.
- Standby power consumption: 0.3 W