Headphone AmplifierPHA-3AC

Connecting to WALKMAN models unsupported by digital-out

Before connecting, turn the volume of your WALKMAN down, and turn the headphone amplifier off.

  1. Turn on the WALKMAN.
  2. Set the INPUT select switch to the position of the AUDIO IN/LINE OUT jack (right edge position).
  3. Set the OUTPUT select switch to (right edge position).
  4. Connect the WALKMAN to the AUDIO IN/LINE OUT jack using the stereo mini cable (supplied).

  5. Connect your headphones to the (headphones) NORMAL jack on the front side of the headphone amplifier.

    When the WALKMAN is connected to the AUDIO IN/LINE OUT jack, your headphones cannot be connected to the (headphones) BALANCED L/R jack.

Note

  • If you connect the headphone amplifier to a WALKMAN with a built-in radio or tuner, broadcasts may not be received, or sensitivity may be reduced significantly.
  • If there is noise in broadcasts, place the headphone amplifier farther away from the connected WALKMAN and check whether reception improves.
Go to Page Top