Personal Audio SystemSRS-X7

Connection method 3: Connecting to a Wi-Fi network using a PC connected wirelessly (Windows 8 UI)

Note that the speaker should be initialized to the factory default for this connection. All BLUETOOTH device registration (pairing) information are deleted.

This section describes how to connect a Windows 8 UI PC and the speaker wirelessly, then connect to a wireless router, using the PC.

Check the following before starting the operation.

  • Disconnect the LAN cable from the speaker.
  • Place the speaker closer to the wireless router.
  • Set the Wi-Fi antenna on the rear to the upright position.
  • Set the NETWORK OFF/ON switch on the rear of the speaker to ON.
  1. Have the Wi-Fi network name (SSID) and password of the wireless router available for reference.

    For details, refer to the operating instructions of your wireless router.

  2. With the speaker turned on, press and hold the VOL (volume) – button and the (on/standby) button at the same time for more than 5 seconds.

    The power of the speaker turns off automatically. The settings of the speaker return to their factory defaults, and network settings and all BLUETOOTH device registration (pairing) information are deleted.

  3. Turn on the speaker.

    The (on/standby) indicator lights up in green, then the LINK indicator begins to flash.

    When you configure the settings of the speaker for the first time after purchase, or after you initialize the speaker, wait until the LINK indicator turns off (about a minute).

  4. Connect the speaker to the PC.
    1. Move the mouse pointer to the top-right (or bottom-right) corner of the Start screen to display the charms, then select [Settings]. In the case of a touch panel, display the charms by swiping from the right side of the Start screen, then select [Settings].

    2. Select the icon or icon.
    3. Select [Sony_Wireless_Audio_Setup] from the network list.
  5. Display the [Sony Network Device Setting] screen.
    1. Launch a browser.
    2. Enter the following URL in the address search bar.
  6. Select the language from [Language Setup].

  7. Select [Network Settings] from the menu.

  8. Select the SSID of the wireless router, and enter the password.

  9. Select [Apply].

  10. Select [OK] in the displayed window.
  11. Check that the LINK indicator lights up in green.

    When the Wi-Fi connection is completed, the LINK indicator lights up in green.

    The connection is complete.

  12. Connect the PC to the wireless router to be used.

Hint

  • If you want to set a fixed IP address, set in the screen in step 7 above.

Note

  • This procedure needs to be completed within 10 minutes. If you cannot complete within 10 minutes, start over from step 2.
  • Until you finish the Wi-Fi network setting, it will not be protected. The Wi-Fi network will be protected again after setting the Wi-Fi security.