Using the Remote Commander
The Remote Commander (supplied) allows you to operate your Walkman wirelessly. The Remote Commander and the Walkman are already paired at the factory, so just turn them on and they are ready to use without pairing.
The power of your Walkman has to be turned on before performing the procedures below.
- Put the Remote Commander on your finger.
If the band does not fit the size of your finger, remove the Remote Commander once and adjust the band, then put it on again.
- Check that your Walkman is turned on.
- Turn on the Remote Commander.
Press and hold the button (
) for more than 2 seconds. When the Remote Commander is turned on, the lamp (
) starts blinking.
Your Walkman and the Remote Commander are automatically connected to each other and
the lamp () turns off.Skip this step if the lamp (
) lights up when you press any of the Remote Commander buttons. The Remote Commander is already turned on. - Press the desired button of the Remote Commander to operate your Walkman.
Hint
- The Remote Commander is automatically turned off when your Walkman is turned off.
- The Remote Commander is automatically turned off if you do not operate it for more than 2 hours.
- If the remaining battery power is low, the lamp () color changes to red.
- You cannot turn on or off your Walkman by the Remote Commander.
- To delete pairing information, press and hold the buttons (
and 
) for about 10 seconds. - If the Remote Commander has no pairing information, it will be in pairing mode automatically when it is turned on.