One of the following messages may appear or flash on the display during operation.
|CANNOT PLAY||A disc that cannot be played back was inserted.|
|DEVICE ERROR||The USB device could not be recognized or an unknown device is connected.|
|DEVICE FULL||The memory of the USB device is full.|
|ERASE ERROR||Erase of audio files or folders on the USB device failed.|
|FATAL ERROR||The USB device was removed during transfer or erase operation, and may have been damaged.|
|FOLDER FULL||You cannot transfer onto the USB device because the number of folders has reached its maximum.|
|NoDEVICE||No USB device is connected or unsupported device is connected.|
|NO DISC||There is no disc in the system.|
|NO MUSIC||No supported audio files exist in the playback source.|
|NO SUPPORT||An unsupported USB device is connected, or the USB device is connected through a USB hub.|
|NOT USE||You tried to perform a specific operation under conditions where that operation is prohibited.|
|OVER CURRENT||An over current from the(USB) port was detected.
Disconnect the USB device from the port.
For details, see [OVER CURRENT] appears on the display.
|PROTECT||The USB device is write-protected.|
|PUSH STOP||You tried to perform an operation that can be performed only when the playback is stopped.|
|READING||The system is reading information of the disc or USB device. Some operations are not available.|
|REC ERROR||The transfer did not start, stopped partway, or otherwise could not be performed.|
|TRACK FULL||You cannot transfer onto the USB device because the number of files has reached its maximum.|