Receiving a call
You can enjoy a hands-free call with a smartphone or mobile phone that supports the BLUETOOTH profile HFP (Hands-free Profile) or HSP (Headset Profile), via a BLUETOOTH connection.
- If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
- Operations may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied with your smartphone or mobile phone.
Ring tone
When an incoming call arrives, a ring tone will be heard from the audio receiver.
The ring tone varies in the following ways, depending on your smartphone or mobile phone.
- Ring tone set on the audio receiver
- Ring tone set on the smartphone or mobile phone
- Ring tone set on the smartphone or mobile phone only for a BLUETOOTH connection
- Connect the audio receiver to a smartphone or mobile phone beforehand.
- When you hear a ring tone, press the multi-function button on the audio receiver and receive the call.
When an incoming call arrives even while you are listening to music, playback pauses and a ring tone will be heard from the audio receiver.
If no ring tone is heard via the audio receiver
- The audio receiver may not be connected with the smartphone or mobile phone with HFP or HSP. Check the connection status on the smartphone or mobile phone.
- If playback does not pause automatically, operate the audio receiver to pause playback.
- Press the multi-function button to adjust the volume.
- Increase volume: Press the multi-function button 2 times consecutively, holding the button down at the second push ().
- Decrease volume: Press the multi-function button 3 times consecutively, holding the button down at the third push ().
- To end the call, press the multi-function button on the audio receiver again.
If you were listening to music when the call arrived, playback will resume when the call ends.
Note
- Depending on the smartphone or mobile phone, playback may not resume automatically even if you finish the call.
- Use a smartphone or mobile phone at least 50 cm away from the audio receiver. Noise may result if the audio receiver and the smartphone or mobile phone are too close.
Hint
- When you adjust the volume, press the button 2 or 3 times with short intervals between each press (about 0.4 seconds) so the operations will be recognized as being consecutive.
- Some smartphones or mobile phones have handset use priority when receiving a call. In the case of the HFP or HSP connection, switch the call device to the audio receiver by holding the multi-function button down for about 2 seconds or by using your smartphone or mobile phone.
- If you adjust the volume on the audio receiver when not talking, the playback volume is adjusted.
- Volume for a call and listening to music can be adjusted independently. Even if you change the volume while playing back music, the volume of a call does not change.