Receiving a call

You can enjoy a hands-free call with a smartphone or mobile phone that supports the BLUETOOTH profile HFP (Hands-free Profile) or HSP (Headset Profile), via a BLUETOOTH connection.

  • If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
  • Operations may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied with your smartphone or mobile phone.
  • This headset supports normal incoming calls only. Calling apps for smartphones and computers are not supported.

Ring tone

When an incoming call arrives, a ring tone will be heard from the headset, and the indicator (blue) flashes quickly.

Also, the left unit of the headset vibrates (Vibration function for receiving a call).

You will hear either of following ring tones, depending on your smartphone or mobile phone.

  • Ring tone set on the headset
  • Ring tone set on the smartphone or mobile phone
  • Ring tone set on the smartphone or mobile phone only for a BLUETOOTH connection
  1. Connect the headset to a smartphone or mobile phone beforehand.
  2. When you hear a ring tone, press button on the headset and receive the call.

    When an incoming call arrives even while you are listening to music, playback pauses and a ring tone will be heard from the headset.

    A: Microphone

    If no ring tone is heard via the headset

    • The headset may not be connected with the smartphone or mobile phone with HFP or HSP. Check the connection status on the smartphone or mobile phone.
    • If playback does not pause automatically, operate the headset to pause playback.
  3. Press the + or - button to adjust the volume.

    When the volume reaches the maximum or minimum, an alarm sounds.

  4. To end the call, press the button on the headset again.

    If you received a call during music playback, music playback resumes automatically.

Hint

  • The default setting of the vibration function for receiving a call is “on.”
    To turn off the function, press and hold both the button and -/ button for about 2 seconds while the headset is on. You will hear a voice guidance which informs the switching of the function and the left unit of the headset vibrates twice briefly.
    To turn on the function again, press and hold both the button and +/ button for about 2 seconds while the headset is on. You will hear a voice guidance which informs the switching of the function and the unit of the headset vibrates for about 1 second.
  • Some smartphones or mobile phones by default receive calls with the phone instead of the headset. With an HFP or HSP connection, switch the call device to the headset by holding the button down for about 2 seconds or by using your smartphone or mobile phone.
  • Volume for a call can be adjusted during a telephone conversation only.
  • Volume during a call and volume during music playback can be adjusted independently. Changing the call volume does not change the volume of music playback, and vice versa.

Note

  • Depending on the smartphone or mobile phone, playback may not resume automatically even if you finish the call.
  • Use a smartphone or mobile phone at least 50 cm(19 3/4 in.) away from the headset. Noise may result if the headset and the smartphone or mobile phone are too close.
  • Your voice is heard from the headset through the headset's microphone (Sidetone function). In this case, the surround sound or sound of the headset operation may be heard through the headset - this is not a malfunction.
Go to Page Top