Sound Settings (Sound)

EXTRA BASS

Reinforces bass sound in synchronization with the volume level: [OFF], [1], [2].


EQ10/Subwoofer

Selects an equalizer curve and adjusts the subwoofer level.
(Available when any source is selected.)

Item Detail
EQ10 Selects the equalizer curve: [OFF], [R&B], [Rock], [Pop], [Hip-Hop], [Dance], [EDM], [Jazz], [Soul], [Country], [Custom].
[Custom] adjusts the equalizer curve: -6 to +6.
Subwoofer Adjusts the volume level of the subwoofer: [OFF], -10 to +10.


DSO (Dynamic Stage Organizer)

Enhances audio output: [OFF], [Low], [Middle], [High].


Balance/Fader

Adjusts the balance/fader level.

Item Detail
Balance Adjusts the sound balance between the left and right speakers: [L15] to [R15].
Fader Adjusts the sound balance between the front and rear speakers: [Front 15] to [Rear 15].


Advanced

Adjusts the sound related settings such as the cut off frequency, the subwoofer, and the speaker connection.

Item Detail
High Pass Filter Selects the cut-off frequency of the front/rear speakers: [OFF], [50Hz], [60Hz], [80Hz], [100Hz], [120Hz]. ([100Hz] is applied when [Subwoofer Direct] is set to [1] to [3] from [OFF]. [OFF] is applied when [Subwoofer Direct] is set to [OFF].)
Low Pass Filter Selects the cut-off frequency of the subwoofer: [OFF], [50Hz], [60Hz], [80Hz], [100Hz], [120Hz].
Subwoofer Direct Selects the mode for the subwoofer connected to the rear speaker lead without a power amplifier: [OFF], [1], [2], [3]. As the setting number increases, the subwoofer audio level increases. When connecting normal speakers to the rear speaker leads, set to [OFF]. (Available only when the source is off.)
  • When connecting a 2Ω or 4 Ω to 8 Ω subwoofer to either of the rear speaker leads, set [Speaker Impedance Load] to [2 Ohm].
  • When using a subwoofer with dual voice coil, or using subwoofer(s) by connecting to the right and left rear speaker leads, set [Speaker Impedance Load] to [2 Ohm].
Subwoofer Phase Selects the subwoofer phase: [Normal], [Reverse].
Speaker Impedance Load Sets the impedance load of the speaker connection: [4 Ohm] (4 Ω load connection), [2 Ohm] (2 Ω load connection). (Available only when the source is off.)
  • Set to [2 Ohm] when connecting as follows:
    - When connecting front speakers in parallel.
    - When connecting subwoofer(s) to right and left rear speaker leads.
    - When connecting a dual voice coil subwoofer with 4 Ω to 8 Ω impedance.
Volume Limiter Sets the limit of the maximum volume to prevent an internal error of the unit: 30 to 50.
Go to Page Top