If indicators appear on the LCD monitor or in the viewfinder, check the following. If the problem persists even after you have tried to fix a couple of times, contact your Sony dealer or local authorized Sony service facility. When you contact them, give them the complete error code beginning with C or E displayed on the LCD monitor.

You may hear a melody when an important warning indicator appears on the LCD monitor.

C:(or E:) : (Self-diagnosis display)

C:04:

You are not using the designated battery pack. Make sure to use the designated battery pack.

Connect the DC plug of the AC Adaptor to the DC IN jack of this product firmly.

C:06:

The battery pack temperature is high. Change the battery pack or place it in a cool place.

C:13: / C:32:

Remove the power source. Reconnect it and operate this product again.

E: :

Follow the steps from 2 on “If you have problems.”

(Battery level warning)

The battery pack is nearly used up.

Depending on the operating environment or battery conditions, may flash even with about 20 minutes of power remaining.

(Warning indicator pertaining to battery pack temperature)

The battery pack temperature is high. Change the battery pack or place it in a cool place.

(Warning indicator pertaining to memory card)

Slow flashing

Free spaces for recording images are running out.

No memory card is inserted.

Fast flashing

There is not enough free spaces for recording images. After storing the images on other media, delete unnecessary images, or format the memory card.

The image data base file may be damaged. Check the data base file by selecting - [Setup] - [Media Settings] - [Repair Img. DB F.] - the recording medium.

The memory card is damaged.

When recording images with [File Format] set to [XAVC S 4K] and [REC Mode] set to [100Mbps ], use an SDXC memory card of UHS-I U3.

(Warning indicators pertaining to memory card formatting)

The memory card is damaged.

The memory card is not formatted correctly.

(Warning indicator pertaining to incompatible memory card)

Incompatible memory card is inserted.

(Warning indicator pertaining to the write-protect of the memory card)

The memory card is write-protected.

Access to the memory card was restricted on another device.

(Warning indicator pertaining to the external device)

The image data base file may be damaged. Check the data base file by selecting - [Setup] - [Media Settings] - [Repair Img. DB F.] - the recording medium.

The external device is damaged.

(Warning indicators pertaining to external device formatting)

The external device is damaged.

The external device is not formatted correctly.

(Warning indicator pertaining to camera-shake warning)

This product is unsteady, so camera-shake easily occurs. Hold this product steady with both hands and record the image. However, note that the camera shake warning indicator does not disappear.

(Warning indicator pertaining to photo recording)

The recording media is full.

Photos cannot be recorded during processing. Wait for a while, then record.

You cannot capture photos while recording movies in the following situations:

• When [REC Mode] is set to [Highest Quality ].
• When [Frame Rate] is set to [60p] (models with NTSC color system) or [50p] (models with PAL color system).
• When an item of [Picture Effect] is selected.
• When [File Format] is set to [XAVC S 4K] and [REC Mode] is set to [100Mbps ].
• When [File Format] is set to [XAVC S 4K] and [Dual Video REC] is set to [On].

• When [Dual Video REC] is set to [On].

Note

• You can select XAVC S 4K and 100 Mbps at the same time when using software version 3.00 or later on FDR-AX100/FDR-AX100E. To confirm the software version, select - [Setup] - [General Settings] - [Version]. (The [Version] menu item will be displayed with software version 2.00 or later.)