About messages
One of the following messages may appear or flash on the display during operation.
| Message | Cause |
|---|---|
| CANNOT PLAY | A disc that cannot be played back was inserted. |
| DATA ERROR |
|
| DEVICE ERROR | The USB device could not be recognized or an unknown device is connected. |
| DEVICE FULL | The memory of the USB device is full. |
| ERASE ERROR | Erase of audio files or folders on the USB device failed. |
| FATAL ERROR | The USB device was removed during transfer or erase operation, and may have been damaged. |
| FOLDER FULL | You cannot transfer onto the USB device because the number of folders has reached its maximum. |
| NoDEVICE | No USB device is connected or unsupported device is connected. |
| NO DISC | There is no disc in the system. |
| NO MUSIC | No supported audio files exist in the playback source. |
| NO SUPPORT | An unsupported USB device is connected, or the USB device is connected through a USB hub. |
| NOT USE | You tried to perform a specific operation under conditions where that operation is prohibited. |
| OVER CURRENT | An over current from the (USB) port was detected.
Disconnect the USB device from the port. For details, see [OVER CURRENT] appears on the display. |
| PROTECT | The USB device is write-protected. |
| PUSH STOP | You tried to perform an operation that can be performed only when the playback is stopped. |
| READING | The system is reading information of the disc or USB device. Some operations are not available. |
| REC ERROR | The transfer did not start, stopped partway, or otherwise could not be performed. |
| TRACK FULL | You cannot transfer onto the USB device because the number of files has reached its maximum. |
