Mounting the Bar Speaker on a Wall

Bar speaker

Note

  • Prepare screws (not supplied) that are suitable for the wall material and stability. Depending on the wall material, the wall may be damaged.
  • Fasten the screws securely in the wall beam.
  • Hang the bar speaker horizontally on the reinforced wall.
  • Have the installation done by a Sony dealer or licensed contractor and pay special attention to safety during the installation.
  • Sony shall not be held responsible for accidents or damage caused by improper installation, insufficient wall stability, improper screw installation, natural disasters, etc.
  • Two or more persons are required to hang the bar speaker for safety.
  1. Prepare two screws (not supplied) that are suitable for the wall mount holes on the rear of the bar speaker.

    Illustration indicating the dimensions of a screw. Use a screw with a thread diameter of 4 mm (3/16 in) and a length excluding the screw head of more than 30 mm (1 3/16 in).

    (a) 4 mm (3/16 in)

    (b) More than 30 mm (1 3/16 in)


    Hole on the rear of the bar speaker

    Illustration indicating the dimensions of the hole on the rear of the bar speaker. The upper part is 5 mm (7/32 in) wide and the lower part is 10 mm (13/32 in) wide.

    (c) 5 mm (7/32 in)

    (d) 10 mm (13/32 in)

  2. Align the vertical line above the “ TV CENTER LINE” printed on the WALL MOUNT TEMPLATE (supplied) with the center of the width of your TV.

    Align the TV CENTER LINE, which is in the center of the width of the WALL MOUNT TEMPLATE, with the center of the width of your TV.

    Center of the TV

    WALL MOUNT TEMPLATE

  3. Align the “ TV BOTTOM LINE” printed on the WALL MOUNT TEMPLATE with the bottom of your TV, then adhere the WALL MOUNT TEMPLATE on the wall with a commercially available adhesive tape, etc.

    WALL MOUNT TEMPLATE

    Adhesive tape, etc.

  4. Fasten the screws prepared in step 1 securely into the screw marks on the “ SCREW LINE” printed on the WALL MOUNT TEMPLATE.

    There are black circle marks indicating the screw mounting positions 270 mm (10 3/4 in) to the left and right of the center of the WALL MOUNT TEMPLATE. Fasten screws into these marks, leaving a length between 10 mm and 11 mm (approx. 7/16 in) between the screw head and the wall.

    Screws

    Marks

    (e) 270 mm (10 3/4 in)

    (f) 10 mm to 11 mm (approx. 7/16 in)

  5. Remove the WALL MOUNT TEMPLATE.
  6. Hang the bar speaker on the screws.

    Align the holes of the rear of the bar speaker with the screws, then hang the bar speaker on the two screws.

    Hang the bar speaker so that the screws mounted in step 4 pass through the holes on the rear of the bar speaker and the bar speaker is hung on the screws.

Note

  • When adhering the WALL MOUNT TEMPLATE on the wall, smooth it out fully.
  • Install the bar speaker apart from the TV by 70 mm (2 7/8 in) or more.
Go to Page Top