About the indicators
CHG (charge) indicator (orange)
Turns off | The speaker has completed charging. |
Lights up | The speaker is being charged. |
Flashes quickly (3 times a second) | An abnormality of the built-in battery has been detected. Stop charging immediately. |
Flashes slowly | The built-in battery is running low and needs to be charged. |
Flashes 3 times and turns off | If the CHG (charge) indicator flashes 3 times and goes off when you turn on the speaker, the built-in battery is empty and needs to be charged. |
Note
-
A speaker that is in use can be charged if it is connected to an AC outlet via a USB AC adaptor (commercially available), or connected to a booted computer. In this case, it may take longer to charge the built-in battery depending on the conditions of use. Therefore, it is recommended to turn off the speaker when charging.
-
When you use the speaker at a loud volume for a long time, the built-in battery may run low even if the speaker is connected to an AC outlet via a USB AC adaptor (commercially available), or connected to a booted computer. As a result, sound becomes low. This is not a malfunction. Turn off the speaker and charge the built-in battery sufficiently.
-
In an extremely cold or hot environment, charging stops for safety. If charging takes a long time, it also makes charging of the speaker stop. To resolve these issues, disconnect the micro-USB cable from the speaker and connect it again within an operating temperature between 5 °C and 35 °C (41 °F and 95 °F).
Power/(BLUETOOTH) indicator (blue)
Lights up | The speaker is connected to a BLUETOOTH device. |
Flashes quickly (3 times a second) | The speaker enters the pairing mode. |
Flashes slowly | The speaker is waiting for a BLUETOOTH device to connect to. |
Flashes once | Each time you press the -/+ (volume) button, the indicator flashes once. |
Flashes 3 times | When you operate the -/+ (volume) button and the volume is set at the lowest or highest level, the indicator flashes 3 times. |
L (left)/R (right) indicators (white)
Flash |
The speaker enters the Speaker Add function. The L (left)/R (right) indicators flash when the connection with the Speaker Add function fails. |
Light up |
The Speaker Add function is used on the speaker. |