One of the following messages may appear or flash on the display during operation.
|A disc that cannot be played back was inserted.
|The USB device could not be recognized or an unknown device is connected.
|The memory of the USB device is full.
|Erase of audio files or folders on the USB device failed.
|The USB device was removed during transfer or erase operation, and may have been damaged.
|You cannot transfer onto the USB device because the number of folders has reached its maximum.
|No USB device is connected or unsupported device is connected.
|There is no disc in the system.
|No supported audio files exist in the playback source.
|An unsupported USB device is connected, or the USB device is connected through a USB hub.
|You tried to perform a specific operation under conditions where that operation is prohibited.
|An over current from the(USB) port was detected.
Disconnect the USB device from the port.
For details, see [OVER CURRENT] appears on the display.
|The USB device is write-protected.
|You tried to perform an operation that can be performed only when the playback is stopped.
|The system is reading information of the disc or USB device. Some operations are not available.
|The transfer did not start, stopped partway, or otherwise could not be performed.
|You cannot transfer onto the USB device because the number of files has reached its maximum.