Listening to music from a device via Bluetooth connection

If your Bluetooth device supports the following profiles, you can enjoy listening to music and perform basic remote control operation of the device from your headset via Bluetooth connection.

  • A2DP（Advanced Audio Distribution Profile）

    You can enjoy high-quality music wirelessly.

  • AVRCP（Audio Video Remote Control Profile）

    You can adjust the volume, etc.

The operation may vary depending on the Bluetooth device. Refer to the operating instructions supplied with the Bluetooth device.

  1. Connect the headset to a Bluetooth device.
  2. Put on the headset.

    Place the neckband around your neck so that the (left) mark is on your left and the (right) mark is on your right. There is a tactile dot on the (left) unit. Put the left and right units in your ears. Adjust the neckband and the left and right units into a position where they fit well.

    Illustration indicating the locations of the tactile dots (A) on the left side of the neckband and the left unit

    A: Tactile dot

  3. Operate the Bluetooth device to start playback and adjust the volume to a moderate level.
  4. Adjust the volume by pressing the +/- buttons of the headset.

    When the volume reaches the maximum or minimum, an alarm sounds.

Hint

  • The headset supports SCMS-T content protection. You can enjoy music and other audio on the headset from a device such as a mobile phone or portable TV that supports SCMS-T content protection.
  • Depending on the Bluetooth device, it may be necessary to adjust the volume or set the audio output setting on the device.
  • The headset volume during a call and during music playback can be independently adjusted. Changing the call volume does not change the volume of music playback and vice versa.

Note

  • If the communication condition is poor, the Bluetooth device may react incorrectly to the operation on the headset.
Go to Page Top