Installing the system on a tripod
You can adjust the height of the system using a tripod (not supplied).
Match the hole on the system (
) to the tripod (
), then gently push it downward until it is inserted completely to the tripod.
Be sure to use tripod of approximately 35 mm (1 7/16 in) in diameter only.
Height: ≤ 1 m (39 3/8 in)
≥ 0.55 m (21 3/4 in)*
35 mm (1 7/16 in)
* We recommend you to expand the tripod legs to maximum.
Note
-
We recommend to use an extension cable (not supplied) if the AC power cord (mains lead) cannot reach a wall outlet.
-
Take the following precautions when installing the system on the tripod to avoid personal injury or damaging the system.
-
Set up the tripod completely before you install the system. Be sure to read the operating instructions of your tripod.
-
Do not install the system on the tripod placed on unstable surface, walkway or any other unsuitable locations.
-
Make sure the system is attached on the tripod securely.
-
Do not push the system or place any objects on the system when it is installed on the tripod.
-
Do not rotate or lift the system when it is installed on the tripod.
-
Do not walk over the tripod legs to avoid from tripping.
-
Disconnect the AC power cord (mains lead) and all cables, and detach the system from the tripod when you want to move the tripod or the system.
-
Be careful not to trip over the tripod legs or the AC power cord (mains lead).
-
Keep children away from the system installed on the tripod.
-
Take other precautions to prevent the system installed on the tripod from falling.
-
