Making a call

You can enjoy a hands-free call with a smartphone or mobile phone that supports the Bluetooth profile HFP (Hands-free Profile) or HSP (Headset Profile), via Bluetooth connection.

  • If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
  • The operation may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied with the smartphone or mobile phone.
  • Only ordinary phone calls are supported. Applications for phone calls on smartphones or personal computers are not supported.
  1. Connect the headset to a smartphone/mobile phone via Bluetooth connection.
  2. Operate your smartphone or mobile phone to make a call.

    When you make a call, the dial tone is heard from the headset.

    If you make a call while you are listening to music, playback pauses.

    If no dial tone is heard via the headset, switch the call device to the headset using your smartphone or mobile phone or by holding your finger to the touch sensor control panel until the device is switched.

    The headset has omnidirectional microphones. You can talk without worrying about the position of the microphone.

  3. Adjust the volume using the touch sensor control panel.
    • Increase the volume: Swipe up repeatedly until the volume reaches the desired level.

    • Decrease the volume: Swipe down repeatedly until the volume reaches the desired level.

    • Change the volume continuously: Swipe up or down and hold. Release at the desired volume level.

    When the volume reaches the maximum or minimum, an alarm sounds.

  4. When you finish your phone call, tap the touch sensor control panel twice quickly (with an interval of about 0.3 seconds) to end the call.

    If you made a call during music playback, music playback resumes automatically after ending the call.

Hint

  • Volume for a call can be adjusted during a telephone conversation only.
  • The headset volume during a call and during music playback can be independently adjusted. Changing the call volume does not change the volume of music playback and vice versa.

Note

  • Use a smartphone or mobile phone at least 50 cm (19.69 in.) away from the headset. Noise may result if the smartphone or mobile phone is too close to the headset.
  • Your voice will be heard from the headset through the headset’s microphone (Sidetone function). In this case, ambient sounds or the sounds of the headset operation may be heard through the headset, but this is not a malfunction.
Go to Page Top