Configuring Connection Control Manager Receiver and Output Settings

Receiver settings and SDI output settings

Configure the IP address and UDP ports used to receive streaming content by the streaming receiver.

And, configure the mode for output of SDI signals from the PWS-110RX1A units.

  1. Log in to the Connection Control Manager from a client PC.
  2. Display the Settings screen and click the [RX] tab.
  3. Select the PWS-110RX1A unit you want to configure.
  4. Enter the name of the PWS-110RX1A unit for display in the Connection Control Manager in [Name].
  5. External Host Name: Enter the IP address or host name for accessing the PWS-110RX1A unit from the Internet.
  6. Enter the number of the first UDP port used for receiving streaming content from the Internet in [External Port Range].
  7. Configure the SDI signals to output.
    • [Resolution]: Select the resolution.
    • [Frame Rate]: Select the frame rate.
    • [Ref Lock]: Select the external sync signal used for synchronization. Select [Free Run] if not using a reference signal to lock the output.
  8. Click [Save RX Settings] to save the settings.
Go to Page Top