Turning Devices On

Use the following procedure to turn on the power when using the PWS-110RX1A.

  1. When configuring PWS-110RX1A preferences, connect a keyboard and mouse to the USB connectors on the front panel, and connect a monitor to the HDMI connector on the rear panel.
    This step can be skipped once the preferences have been configured on the PWS-110RX1A. Check that the unit is connected correctly to the network.
  2. Press the PWS-110RX1A On/Standby button.
    The On/Standby button indicator lights up green.
  3. When the Windows sign-in screen appears on the display, enter the user name and password to sign in.
    The factory default user name is “rx1” and the default password is “rx1”. If the user name and password were changed during preferences configuration, enter the new user name and password when subsequently signing in.

To turn the power off

Press and hold the PWS-110RX1A On/Standby button for two seconds or longer. The PWS-110RX1A enters standby state, and the On/Standby button indicator lights up red.

Note

  • There is no power switch on the PWS-110RX1A. The unit is in either standby state or on state when the power cord is connected. The power can be completely turned off by disconnecting the power cord, but first check that the PWS-110RX1A is in standby state (On/Standby button indicator is lit red) before removing the power cord.
  • To ensure security, make sure to change the default password.
  • If prompted to change the password when signing in, set a new password.
Go to Page Top