Using the supplied headphone cable

If you use the headset at a place where it is restricted to use Bluetooth devices such as on an airplane, you can use the headset as noise canceling headphones by connecting a device via the supplied headphone cable and turning the headset on.

When the headset is turned on, the indicator (green) next to the NC button lights up (the noise canceling function: ON) or flashes (the noise canceling function: OFF).

  1. Connect a playback device to the INPUT jack with the supplied headphone cable.

    Make sure you connect the L-shaped plug to the playback device.

Hint

  • You can enjoy music by connecting the supplied headphone cable to the headset even when the headset is turned off. In this case the noise canceling function is not available.
  • The headset turns off automatically if you disconnect the supplied headphone cable while the headset is turned on.
  • When an incoming call arrives, a ring tone will be heard via the headphones. Answer the call using your smartphone or mobile phone, and talk using the microphone of the phone. You can hear the voice of the caller from the headphones.
  • If you disconnect the headphone cable from the smartphone or mobile phone, you can talk using the microphone and speaker of the phone.

Note

  • Use the supplied headphone cable only.
  • Make sure you insert the plug firmly.
  • When using the headphone cable the Bluetooth function cannot be used.
  • The Jog switch (/ (play/call), (previous), (next)) and VOL +/- cannot be used. For volume, playback, pausing, etc., control with the connected device.
  • The NC button cannot be used when the headset is powered off.
Go to Page Top