Pairing the sensors

When using the device for the first time, pair the sensors with the mocopi app.
  1. Find and tap the mocopi app on your smartphone to launch the app.
  2. On the initial setup screen, tap [SET UP].

    Follow the on-screen instructions to proceed with the setup.

  3. On the [Pairing the sensors] screen, tap [NEXT].

    Follow the on-screen instructions to set up the pairing.
    When the [Pairing request] screen appears, tap [PAIR & CONNECT] > [PAIR].
    When pairing is complete, the [Connecting the sensors] screen appears.

Hint

  • If the [Pairing request] screen disappears, swipe down on the screen to display the message.

Note

  • Check that the Bluetooth function for your smartphone is enabled before pairing the sensors.
  • If the pairing of the sensors failed, check the following.
    • If the sensors are turned off, turn them on.
    • If another Bluetooth device is connected to your smartphone, disconnect it.
    • If the sensors are connected to another smartphone, disconnect them.
    • Turn off the sensors, wait for about 10 seconds, and then turn them on again.
    • If the sensors have previously been paired with your smartphone, delete them on the Bluetooth device list on your smartphone.
    • Restart your smartphone.
    • Reset the sensors. To reset a sensor, press the power button 10 times. The reset is complete when the indicator flashes in red and blue alternately. The Bluetooth device information registered to the sensor is erased by the reset.
  • If you cannot turn on the sensor, check the following.
    • The battery level may be low. Charge the sensor.
    • If the sensor is charged but you cannot turn on the power, press and hold the button on the sensor for 5 seconds to restart.

Unpairing the sensors

  1. On the [Sensor status] screen, tap (menu icon) for the sensor you want to unpair.
  2. Tap [UNPAIR].
Go to Page Top
TP1001055225