Attaching the connector protect holder/stand

Before carrying around the receiver, attach the connector protect holder/stand (supplied) to the receiver.

  1. Slide the Multi Interface foot of the receiver into the connector protect holder/stand until it clicks into place.

    Slightly push down and hold the retention latch () on the connector protect holder/stand, and then slide the receiver into the connector protect holder/stand.

To remove the connector protect holder/stand

Slightly push down and hold the retention latch () on the connector protect holder/stand, and then pull out the receiver.

Hint

  • When placing the receiver away from a camera, attach the connector protect holder/stand to the receiver. Then you can place and use the receiver on a flat surface.

  • The connector protect holder/stand can be screwed to a tripod through the screw hole for tripod attachment (1/4 in. in diameter) on the connector protect holder/stand as well.

    To screw the connector protect holder/stand to the tripod, use a tripod with the screw that is shorter than 5.5 mm (7/32 in.) in length. To a tripod with the longer screw, the connector protect holder/stand cannot be secured firmly and may be damaged by the screw.

Note

  • When you do not intend to use the receiver, attach the connector protect holder/stand to the Multi Interface foot for connector protection.