Cont. Bracket
Shoots multiple images while automatically shifting the exposure from base to darker and then to lighter. You can select an image that suits your purpose after recording.
-
Select
(Bracket) by turning the drive mode dial.
- Turn the drive mode dial while holding down the drive mode dial lock release button.
-
MENU →
(Shooting) → [Drive Mode] → [Bracket Settings] → [Bracket Type] → [Cont. Bracket] → select the desired exposure value and the number of images you want to shoot.
- When setting to record two images, you can select whether to adjust the exposure to the + (over) or - (under) side.*
-
If you register [Drive Mode] to the function menu, you can also display the setting screen for [Bracket Type] from the function menu.*
*When the camera’s system software (firmware) is Ver.3.00 or later.
-
Adjust the focus and shoot the image.
- Keep pressing and holding the shutter button until bracket shooting is finished.
Menu item details
- Exposure Value*:
- Sets the amount by which the exposure value is adjusted during bracketing shooting.
- Number of Shots*:
- Sets the number of images to shoot during bracketing shooting.
* When the camera’s system software (firmware) is Ver.3.00 or later.
Hint
- The last shot is shown on the auto review.
Note
- When [ISO AUTO] is selected in [Manual Exposure] mode, the exposure is changed by adjusting the ISO value. If a setting other than [ISO AUTO] is selected, the exposure is changed by adjusting the shutter speed.
- When the exposure is compensated, the exposure is shifted based on the compensated value.
- Bracket shooting is unavailable in the following shooting modes:
- [Intelligent Auto]
- When [
Picture Profile] is set to other than [Off]
- When the flash is used, the product performs flash bracket shooting, which shifts the amount of flash light even if [Cont. Bracket] is selected. Press the shutter button for each image.
TP1001326774