Using an external wired microphone

You can output your voice from the speaker by connecting a dynamic microphone with a normal plug (Φ 6.3 mm) (commercially available).

  1. Turn the MIC and GUITAR level knob to MIN to reduce the microphone volume level.

  2. Connect an external wired microphone to the MIC/GUITAR jack on the top surface of the speaker.

  3. Adjust the volume using the MIC and GUITAR level knob.
  4. Speak or sing into the connected wired microphone.

    With KEY CONTROL or ECHO on the speaker, you can perform the following operations as well.

    Key Control

    You can change the key of a song you sing.

    Press KEY CONTROL (flat)/(sharp) on the speaker to adjust the key to suit your vocal range.

    Mic Echo

    You can add the echo effect to your voice when you sing into the wired microphone.

    Press ECHO on the speaker repeatedly to adjust the echo effect.

Note

  • When using the Party Connect or Stereo Pair function, sound from the microphone is only output from the speaker to which the microphone is connected.

  • Bringing the microphone close to the speaker may cause acoustic feedback. When this happens, depending on the sound volume of the speaker, the speaker may turn off due to the product protection feature. In that case, disconnect the AC power cord (mains lead), wait for a while, plug in the AC power cord (mains lead), and then turn on the speaker again.

  • While a microphone or a guitar is connected to the speaker, the Auto Standby function is turned off.

  • The port, connector, and jacks on the speaker are not designed for water resistant. Do not use the speaker in places where the speaker is likely to have water splashed on it. When you are finished with using the speaker, be sure to securely close the caps.