Select Finder/Monitor

still image, movie, slow&quick motion

Sets the method for switching the display between the viewfinder and the monitor.

  1. MENU → (Setup) → [Finder/Monitor] → [Select Finder/Monitor] → desired setting.

Menu item details

Auto: 1:
When you look into the viewfinder, the display is switched to the viewfinder automatically.
The eye sensor is deactivated and the display does not switch to the viewfinder depending on whether the monitor is open or closed and the angle of the monitor.
  • You can set [Shutter Half Press Switch] by pressing the right side of the control wheel while [Auto: 1] is selected. If you set [Shutter Half Press Switch] to [On], the display will not switch to the viewfinder until you press the shutter button halfway, even if you look into the viewfinder.
Auto: 2:
When you look into the viewfinder, the display is switched to the viewfinder automatically.
The eye sensor is always activated and the display switches to the viewfinder regardless of whether the monitor is open or closed and the angle of the monitor.
  • You can set [Shutter Half Press Switch] by pressing the right side of the control wheel while [Auto: 2] is selected. If you set [Shutter Half Press Switch] to [On], the display will not switch to the viewfinder until you press the shutter button halfway, even if you look into the viewfinder.
VF(Manual):
The monitor is turned off and the image is displayed only in the viewfinder.
Monitor(Manual):
The viewfinder is turned off and the image is always displayed on the monitor.

Hint

  • You can assign the [Select Finder/Monitor] function to your preferred key.
    [Custom Key/Dial Set.], [Custom Key/Dial Set.] or [Custom Key Setting] → set [Finder/Monitor Sel.] to the preferred key.
  • If you want to retain the viewfinder display or the monitor display, set [Select Finder/Monitor] to [VF(Manual)] or [Monitor(Manual)] beforehand.
    You can keep the monitor off when you take your eyes off the viewfinder during recording by setting the monitor display to [Monitor Off] using the DISP button. Select [DISP (Screen Display)]/[DISP (Screen Display)] → [Monitor] and add a check mark to [Monitor Off] beforehand.
  • When [Auto: 1] or [Auto: 2] is selected, if your hand or body approaches the eye sensor, the display may switch to the viewfinder, and the monitor may turn off, even when you are not looking into the viewfinder. By setting [Shutter Half Press Switch] to [On], you can prevent the display from switching unintentionally to the viewfinder.
  • When [Enlarge Menu Scrn] under [Enlarge Screen] is set to anything other than [Off], a message is displayed confirming whether to change the setting for [Select Finder/Monitor]. When using the [Enlarge Screen] function, it is recommended that you set [Select Finder/Monitor] to [Monitor(Manual)] or to [Auto: 1]/[Auto: 2] with [Shutter Half Press Switch] set to [On]. This will prevent the eye sensor from activating and switching to the viewfinder display when you bring your face close to the monitor.

Note

  • Under strong light sources such as sunlight, the eye sensor may not detect your eye approaching and the display may not switch to the viewfinder even when [Select Finder/Monitor] is set to [Auto: 1] or [Auto: 2]. In such cases, keep the eye sensor from being exposed to the light source.
TP1001931463