Wireless Noise Canceling Stereo HeadsetWF-SP800N

On water resistant/dust proofing performance of the headset

• The charging case is not water resistant/dust proofing.
• The water resistant specifications of this headset are equivalent to IPX5 in IEC 60529 “Degrees of protection against ingress of water (IP Code)”, which specifies the degree of protection provided against the entry of water, and the dust proofing specifications of this unit are equivalent to IP5X in IEC 60529 “Degrees of protection against solid foreign objects (IP Code)”, which specifies the degree of protection provided against the entry of solid foreign objects.
  Unless the headset is used correctly, water or dust may get into the headset and cause fire, electrocution, or malfunctions. Note the following cautions carefully and use the headset correctly.
  IPX5: The headset will maintain its operability even when exposed to direct jet streams of water from any direction (except for the sound conduits (sound output tubes) of the headset).
  IP5X: The headset will maintain its safety and satisfactory operation in the event of an ingress of dust.
• The sound conduits (sound output tubes) of the headset are not completely watertight.

Liquids that the water resistant performance specifications apply to

The water resistant/dust proofing performance of the headset is based on measurements performed by Sony under the conditions described above. Note that malfunctions resulting from water immersion caused by customer misuse are not covered by the warranty.

To maintain water resistant/dust proofing performance

Carefully note the precautions below to ensure proper use of the headset.

• Do not splash water forcibly into the sound output holes.
• Do not drop the headset into water, and do not use underwater.
• Do not allow the headset to remain wet in a cold environment, as the water may freeze. To prevent malfunction, make sure to wipe off any water after use.
• Use a soft dry cloth to wipe off any water that gets on the headset. If water remains in the sound output holes, the sound may become muffled or completely inaudible. If this happens, remove the earbuds, position the sound output holes facing downward, and shake several times to get the water out.

  

• Turn the microphone hole downward and gently tap it about 5 times towards a dry cloth etc. If any water drops are left in the microphone hole, it may cause corrosion.

  

• If the headset is cracked or deformed, refrain from using the headset near water or contact your nearest Sony dealer.