Vision ExchangePEQ-C100/C130

There are four tabs on the [Video Conferencing] page.

[H.323] tab

Use this tab to configure settings relating to H.323.

[Device Name]

Enter the device name.

[H.323 Name]

Enter the H.323 name to register with the gatekeeper.

[Phone Number]

Enter the E.164 number to register with the gatekeeper.

[Gatekeeper Address / FQDN]

Enter the IP address or FQDN of the gatekeeper.

[Gatekeeper Port]

Enter the port number of the gatekeeper.

[Gatekeeper User name]

Enter the user name for logging in to the gatekeeper.

[Gatekeeper Password]

Enter the password for logging in to the gatekeeper.

[Signaling Port]

Enter the port number used for signaling.

[H.245 RTP Port Base]

Enter the fixed RTP port number.

[H.245 RTP Port Range]

Enter the RTP port number range.

[Enable Gatekeeper Multicast Discovery]

Place a check mark here to enable gatekeeper auto discovery.

[H.323 RAS Multicast Address]

Enter the multicast address used by RAS.

[H.323 RAS Multicast Port]

Enter the multicast port number used by RAS.

[Enable NAT Traversal]

Place a check mark here to enable NAT traversal.

[Add H.245 Address To Connect]

Place a check mark here to add the H.245 address to those allowed to be connected.

[SIP] tab

Use this tab to configure settings relating to SIP.

[Display Name]

Set the name displayed to the remote party for an outgoing call.

[SIP ID]

Enter the SIP user name.

[Phone Number]

Enter the telephone number for SIP.

[Transport Type]

Select the transport type used by SIP.

[Registrar Address]

Enter the address of the SIP registrar.

[Registrar Port]

Enter the port number used when communicating with the SIP registrar.

[Registrar Username]

Enter the user name to register with the SIP registrar.

[Registrar Password]

Enter the password to register with the SIP registrar.

[Outbound Proxy Address]

Enter the address of the outbound proxy.

[Outbound Proxy Port]

Enter the port number used when communicating with the outbound proxy.

[Signaling Port]

Enter the port number used for signaling.

[STUN Standard]

Select the standard used by the STUN protocol.

[STUN Server Address]

Enter the address of the STUN server.

[STUN Server Port]

Enter the port number used when communicating with the STUN server.

[STUN Server User name]

Enter the user name to register with the STUN server.

[STUN Server Password]

Enter the password to register with the STUN server.

[Use Secret Binary for STUN User name and Password]

Place a check mark here to use secret binary for the STUN user name and password.

[Check Subnet]

Place a check mark here to check the subnet.

[Camera] tab

Use this tab to configure settings relating to cameras, microphones, and speakers.

Select the camera to configure from the pull-down menu.

Drag the image to adjust the pan and tilt of the camera.

[Camera Zoom]

Adjust the camera zoom using the slider.

[Camera Focus]

Adjust the camera focus using the slider.

[Camera Iris]

Adjust the camera iris using the slider.

[Microphone]

Adjust the microphone volume using the slider.

[Speaker]

Adjust the speaker volume using the slider.

[Audio/Video] tab

Use this tab to configure settings relating to video and audio for video conferencing.

[Max video frame rate]

Select the maximum value for the video frame rate.

[Max Video Bandwidth]

Select the maximum value for the bandwidth available for use during video conferencing.

The frame rate of the camera image and presentation screen, and [Audio Bandwidth] are automatically adjusted to fit within the set bandwidth.