Setting Advertisement

Change the Advertisement control protocol settings from the [Advertisement / PJ Talk / PJ Link] page.

Note

  • The entered value will not be applied until [Apply] is clicked.
  1. Click the [Advertisement / PJ Talk / PJ Link] tab and display the [Advertisement / PJ Talk / PJ Link] page.

  2. Configure each item under [Advertisement] and click [Apply].

Settings

[Start Advertisement Service]

Turn Advertisement on or off. The settings related to Advertisement are applied only if it is on. It is off in the default factory setting.

  • [Community]: Enter the community names for Advertisement and PJ Talk. If changed, the PJ Talk community name changes as well. Only entries consisting of four alphanumeric characters are allowed. The default factory setting community name is “SONY.” To avoid unauthorized access to the projector from another computer, we recommend changing the community name from the one in the factory setting.
  • [Port No.]: Enter the Advertisement transmission port. The default factory setting Advertisement transmission port is “53862.”
  • [Interval]: Enter the Advertisement transmission interval (seconds). The Advertisement transmission interval in the default factory setting Advertisement transmission port is “30.”
  • [Broadcast Address]: Enter the Advertisement data transmission recipient. If nothing is entered, it will be broadcast on the same subnet.
Go to Page Top