Correcting a Vertical Trapezoid
If the screen is trapezoidal, perform a keystone correction.
-
Press the KEYSTONE key on the Remote Commander once.
The adjustment menu will be displayed.
You can also display the adjustment menu from [V Keystone] in the
[Installation] menu. -
Adjust the value with the
/
/
/
(Up/Down/Left/Right) keys.A: Increasing the value in the positive direction makes the upper side screen width smaller.
B: Increasing the value in the negative direction makes the lower side screen width smaller.
Press the RESET key to return to the non-corrected state.
Note
- Because keystone correction is an electronic form of correction, the image quality may be reduced.
- If vertical correction (V keystone correction) and horizontal adjustment (H keystone correction) are performed at the same time, the values in each adjustment menu may not reach the maximum.
- If you press the KEYSTONE key on the Remote Commander and switched between keystone correction and corner keystone correction, the adjustment menu value and the screen state may not match until the adjustment begins.
