Data ProjectorVPL-PHZ61/PHZ51

Remote Commander

Control panel

1. / (On/Standby) key
   Turn on/Standby.
2. INPUT (Input selection) key
   Select the input.
3. MENU (Menu) key
   RESET (Reset) key
   ENTER (Enter)/ / / / (Arrow) keys
   RETURN (Return) key
   Perform menu operations, etc.
4. ASPECT (Aspect) key
   Switch the aspect ratio of the projected image.
   KEYSTONE (Trapezoidal correction) key/PATTERN (Pattern) key
   Adjust the projected image.
   APA (Auto Pixel Alignment) key
   Adjust the input signal to fit to the screen automatically when there is a computer signal being input from the RGB input terminal (Input A).
5. D ZOOM (Digital zoom) +/- key
   Zoom in or out on a part of the projected image. This can be used when there is a computer signal being input. However, depending on the input signal resolution, it may not be usable.
   BLANK (Eliminate image) key
   Temporarily turn off the projected image. Press again to release.
   MUTING (Mute) key
   When sound is output, temporarily mute the audio. Press again to release.
   VOLUME (Sound volume) +/- key
   Adjust the sound volume.
   FREEZE (Freeze) key
   Temporarily freeze the image. Press again to release.
6. ECO MODE (Eco Mode) key
   Allows you to set to Eco Mode.
7. Infrared transmitter

Remote Commander Operation

• Direct the Remote Commander toward the remote control receiver.
• The shorter the distance between the Remote Commander and the projector, the wider the angle within which the Remote Commander can control the projector.
• If there is any obstruction between the Remote Commander and the remote control receiver on the projector, the projector may not be able to receive signals from the Remote Commander.