Menu Operation: HDBaseT Settings

Configure a connection to an HDBaseT device.

  1. Press the MENU key.
  2. Select [Connection/Power] - [Network Setting] - [HDBaseT Settings] - The desired setting.

Settings

[LAN Setting]

[via HDBaseT]/[LAN Port]: You can select either via the LAN of the HDBaseT device connected to the HDBaseT terminal or via the network connection with the LAN terminal of the main unit.

[RS-232C Setting]

  • [via HDBaseT]: You can connect this unit to the RS-232C terminal via the HDBaseT transmitter. (Baud rate: 9,600 bps)
  • [RS-232C]: Use when connecting to the RS-232C terminal of this unit directly. (Baud rate: 38,400 bps)

[Extron XTP]

[On]/[Off]: Set to [On] when connecting the HDBaseT terminal of this unit to XTP Systems manufactured by Extron Electronics. Set to [Off] when connecting to other equipment.

Note

  • When connecting via HDBaseT, only the 100BASE-TX can be used for connection. When using the LAN terminal of the main unit, you can connect with the 10BASE-T/100BASE-TX/1000BASE-T.
  • The IP addresses when using HDBaseT and when using the LAN terminal should be set respectively.
    • Setting the IP address when using a LAN via HDBaseT.
      Set [LAN Setting] to [via HDBaseT] in [HDBaseT Settings], then set the IP address in [Network Setting].
    • Setting the IP address when using the LAN terminal.
      Set [LAN Setting] to [LAN Port] in [HDBaseT Settings], then set the IP address in [Network Setting].
  • For details on XTP Systems, refer to the product catalog or brochure from Extron Electronics.
Go to Page Top