Controlling the audio device (Bluetooth connection)
If your Bluetooth device supports the AVRCP profile’s operating function, the following operating procedures are available. The available functions may vary depending on the Bluetooth device, so refer to the operating instructions supplied with the device.
You can use the touch sensor control panel to perform the following actions.
- To play or pause:
Tap twice quickly with an interval of about 0.4 seconds between taps.
- To skip to the beginning of the next track:
Swipe forward and release.
- To skip to the beginning of the previous track or the current track during playback:
Swipe backward and release.
- To fast-forward:
Swipe forward and hold. It takes a while until fast-forwarding starts. Release at the desired playback point.
- To fast-reverse:
Swipe backward and hold. It takes a while until fast-reversing starts. Release at the desired playback point.
- To increase the volume:
Swipe up repeatedly until the volume reaches the desired level.
- To lower the volume:
Swipe down repeatedly until the volume reaches the desired level.
- To change the volume continuously:
Swipe up or down and hold. Release at the desired volume level.
When the volume reaches the maximum or minimum, an alarm sounds.
Note
- If the communication condition is poor, the Bluetooth device may malfunction in response to the operating procedure on the headset.
- The available functions may vary depending on the connected device, the music software, or app used. In some cases, the device may function differently or may not work even if the above operating procedures described are performed.
TP1002085443