When you have finished using the headset

When you have finished using the headset, be sure to set the headset units into the charging case.

Close the charging case lid.

Note

  • If perspiration or water is left on the charging port, it may impair the ability to charge the headset. Immediately wipe off any perspiration or water on the charging port after use. When the charging ports of the headset units or charging case get dirty, wipe them clean with a soft dry cloth.

    Illustration indicating the locations of the charging ports (A) on the left and right headset units

    Illustration indicating the locations of the left and right charging ports (B) of the charging case

    A: Charging ports of the headset units (left, right)

    B: Charging ports of the charging case (left, right)

When the headset gets wet

  1. Use a soft dry cloth to wipe off any water that gets on the headset.

  2. Remove the earbud tips, turn the sound conduits (sound output tubes) downward, and shake several times to get the water out.

  3. Turn the microphone part or air hole part downward and gently tap it about 5 times on a dry cloth, etc. to remove any water collected inside.

  4. Leave the headset to dry in room temperature.

Go to Page Top