Registering Transmitters (TX)

Register camcorders with a CBKWA100/101 Wireless Adapter attached, camcorders with wireless function, and XDCAM pocket that will transmit a stream or recorded video in C3 Portal, and configure the user name and password used for authentication.

Note

  • For XDCAM pocket, first configure XDCAM pocket for connection with C3 Portal, and then connect to C3 Portal. The connected XDCAM pocket is displayed in the list and “pending” is displayed in the [Status] field. Set [Group] and click the [Save] button. The XDCAM pocket name that is displayed is the setting configured in XDCAM pocket, not the C3 Portal setting.

  1. Select the [Transmitter] page on the [Settings] screen.
  2. Click the (Add) button.
    A row is added to the bottom of the list.
  3. Configure the transmitter information in the added row.
    For each item, enter text directly in the added row or select a value from a drop-down list.
    • [Name]: Enter a name used to identify the transmitter.
    • [Group]: Select a group.
    • [Model Name]: Select the model name of the transmitter. You can enter a name directly if the model does not appear in the drop-down list.
    • [Serial No.]: Associate the serial number with the transmitter.
    • [Software Version]: Displays the software version of the transmitter.
    • [Metadata]: Place a check mark here to send a story received from a planning interface to a camcorder.
    • [Status]: When the connection with a registered transmitter is established, this changes to “ready.”
  4. Repeat steps 2 and 3 as required to register other transmitters.
  5. When finished registering transmitters, click the [Save] button.
  6. Select the [Intercom] page on the [Settings] screen.
  7. Select the audio channel used for communication for each registered transmitter.

    Select the audio channel in the [Receiver Audio Ch] field for each transmitter. If a PWS-110RX1A has not yet been registered as a receiver, first register a receiver.

    Note

    • To select a camcorder in the intercom settings, the transmitter must be registered in this service and the [Status] value must be “ready.”
  8. When finished setting the audio channels, click the [Save] button.
Go to Page Top