Setting ADCP

Change the ADCP control protocol settings from the [ADCP] page.

Note

  • The entered value will not be applied until [Apply] is clicked.
  1. Click the [ADCP] tab and display the [ADCP] page.

  2. Configure each item and click [Apply].

Settings

[Start ADCP Service]

Turn ADCP on or off. The settings related to ADCP are applied only if it is on. It is off in the default factory setting.

  • [Requires Authentication]: Turn the ADCP authentication function on or off. The web page administrator password is set for the password.
  • [Port No.]: Enter the ADCP server port. The default factory setting ADCP server port is “53595.”
  • [Timeout]: Enter the time (in seconds) until the connection is cut when ADCP communication is interrupted. The time in the default factory setting is “60.”
  • [Host Address]: Enter the IP address allowed to be received by the ADCP server. If nothing is entered, commands can be received from any IP address. Once an IP address has been entered, access will only be allowed from the entered IP address. For security purposes, we recommend entering an IP address and restricting access.
Go to Page Top