Parts and Controls (Remote Commander and Control Panel)

Remote Commander

Illustration of the remote commander

Control panel

Illustration of the control panel of the projector

  1. /(On/Standby) key
    Turn on/Standby.
  2. INPUT (Input selection) key
    Select the input.
  3. MENU (Menu) key
    RESET (Reset) key
    ENTER (Enter)////(Arrow) keys
    RETURN (Return) key
    Perform menu operations, etc.
  4. ASPECT (Aspect) key
    Switch the aspect ratio of the projected image.
    KEYSTONE (Trapezoidal correction) key/PATTERN (Pattern) key
    Adjust the projected image.
    APA (Auto Pixel Alignment) key
    Adjust the input signal to fit to the screen automatically when there is a computer signal being input from the RGB input terminal (Input A).
  5. D ZOOM (Digital zoom) +/- key
    Zoom in or out on a part of the projected image. This can be used when there is a computer signal being input. However, depending on the input signal resolution, it may not be usable.
    BLANK (Eliminate image) key
    Temporarily turn off the projected image. Press again to release.
    MUTING (Mute) key
    When sound is output, temporarily mute the audio. Press again to release.
    VOLUME (Sound volume) +/- key
    Adjust the sound volume.
    FREEZE (Freeze) key
    Temporarily freeze the image. Press again to release.
  6. ECO MODE (Eco Mode) key
    Allows you to set to Eco Mode.
  7. Infrared transmitter


Remote Commander Operation

  • Direct the Remote Commander toward the remote control receiver.
  • The shorter the distance between the Remote Commander and the projector, the wider the angle within which the Remote Commander can control the projector.
  • If there is any obstruction between the Remote Commander and the remote control receiver on the projector, the projector may not be able to receive signals from the Remote Commander.