Receiving a call

You can enjoy a hands-free call with a smartphone or mobile phone that supports the Bluetooth profile HFP (Hands-free Profile) or HSP (Headset Profile), via a Bluetooth connection.

  • If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
  • The operation may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied with your smartphone or mobile phone.
  • The headset only supports normal incoming calls. Calling apps for smartphones and computers are not supported.

Ring tone

When an incoming call arrives, a ring tone will be heard from the headset, and the indicator (blue) flashes quickly.

You will hear either of following ring tones, depending on your smartphone or mobile phone.

  • Ring tone set on the headset
  • Ring tone set on the smartphone or mobile phone
  • Ring tone set on the smartphone or mobile phone only for a Bluetooth connection
  1. Connect the headset to a smartphone or mobile phone beforehand.
  2. When you hear a ring tone, double-tap the touch sensor control panel lightly (about 0.4-second interval) and receive the call.

    When an incoming call arrives while you are listening to music, playback pauses and a ring tone will be heard from the headset.

    If no ring tone is heard via the headset

    • The headset may not be connected with the smartphone or mobile phone over HFP or HSP. Check the connection status on the smartphone or mobile phone.
    • If playback does not pause automatically, operate the headset to pause playback.
  3. Adjust the volume by operating the touch sensor control panel.
    • To increase the volume: Swipe up repeatedly until the volume reaches the desired level.

    • To decrease the volume: Swipe down repeatedly until the volume reaches the desired level.

    • If you hold your finger to the touch sensor control panel after swiping up or down, the volume continues to change.

    When the volume reaches the maximum or minimum, an alarm sounds.

  4. To end the call, double-tap the touch sensor control panel lightly again.

    If you received a call during music playback, music playback resumes automatically.

Hint

  • Some smartphones or mobile phones receive calls with the phone instead of the headset by default. With an HFP or HSP connection, switch the call by placing your finger on the headset’s touch sensor control panel until it switches or by using your smartphone or mobile phone.
  • Volume for a call can be adjusted during a telephone conversation only.
  • The headset volume during a call and during music playback can be independently adjusted. Changing the call volume does not change the volume of music playback and vice versa.

Note

  • Depending on the smartphone or mobile phone, playback may not resume automatically even if you finish the call.
  • Use a smartphone or mobile phone at least 50 cm away from the headset. Noise may result if the smartphone or mobile phone are too close to the headset.
Go to Page Top